Command Reference Wireless Security Commands
Ruijie(wlansec)# security wpa disable
Related
Commands
Command Description
security wpa akm { psk | 802.1x } { enable |
disable }
Configures an authentication method in the
WPA authentication mode.
security wpa ciphers { aes | tkip } { enable |
disable }
Configures an encryption method in the WPA
authentication mode.
security wpa akm psk set-key ascci
Configures the shared password in the WPA
authentication mode.
Platform
Description
N/A
security wpa akm
The command is used to configure an authentication method for a WLAN in the WPA authentication
mode. This command has no no prefix, and any configuration prefixed with no does not work at all.
The command format is:
security wpa akm { psk | 802.1x } { enable | disable }
Parameter
Description
Parameter Description
psk
Indicates to configure the authentication method to pre-shared key
identity verification.
802.1x
Indicates to configure the authentication method to IEEE802.1x
authentication.
enable
Indicates that you enable an authentication method in the WPA
authentication mode.
disable
indicates to disable an authentication method in the WPA
authentication mode.
Defaults
N/A
Command
mode
WLAN security configuration mode.
Usage Guide
The command is used to enable an authentication method in the WPA authentication mode. Only
after the WPA authentication mode is enabled can an authentication method be configured. There are
two authentication methods: PSK and 802.1x. When you use the WPA authentication, you need to
configure an encryption method and an authentication method. If only an encryption or authentication
method is configured, or neither is configured, the wireless client cannot be associated with the
wireless network.