Command Reference Syslog Commands
Usage Guide
By default, the source address of the log messages sent to the syslog server is the address of the
sending interface. For easy tracing and management, this command can be used to fix the source
address of all log messages as an interface address, so that the administrator can identify which
device is sending the message through the unique addresses. If the source interface is not configured
on the device, or no IP address is configured for the source interface, the source address of the log
messages is the address of the sending interface.
Configuration
Examples
The following example specifies loopback 0 as the source address of the syslog messages:
Ruijie(config)# logging source interface loopback 0
Related
Commands
Command Description
logging
Sends logs to the Syslog server.
Platform
Description
N/A
logging synchronous
Use this command to enable synchronization function between user input and log output in line
configuration mode to prevent interruption when the user is keying in characters. Use the no form of
this command to disable this function.
logging synchronous
no logging synchronous
Parameter
Description
Parameter Description
N/A N/A
Defaults
The synchronization function between user input and log output is disabled by default.
Command
Mode
Line configuration mode
Usage Guide
This command enables synchronization function between user input and log output, preventing the
user from interrupting when keying in the characters.
Configuration
Examples
Ruijie(config)#line console 0
Ruijie(config-line)#logging synchronous
Print UP-DOWN logs on the port when keying in the command, the input command will be output
again:
Ruijie# configure terminal
Oct 9 23:40:55 %LINK-5-CHANGED: Interface GigabitEthernet 0/1, changed state
To Next Page
Loading...
Need help?
General
