Ruijie RG-WLAN Series

Command Reference IPv6 Commands
A general prefix could contain multiple prefixes.
These longer specified prefixes are usually used for the Ipv6 address configuration on the interface.
Configuration
Examples
The following example configures manually a general prefix as my-prefix.
Ruijie(config)# ipv6 general-prefix my-prefix 2001:1111:2222::/48
Command Description Related
Commands
ipv6 address
prefix-name
sub-bits/prefix-length
Configure the interface address using the general prefix.
show ipv6 general-prefix Show the general prefix.
Platform
Description
N/A
ipv6 hop-limit
Use this command to configure the default hop count to send unicast messages in the global
configuration mode.
ipv6 hop-limit value
no ipv6 hop-limit
Parameter Description Parameter
Description
N/A N/A
Defaults
The default is 64.
Command
Mode
Global configuration mode.
Usage Guide
This command takes effect for the unicast messages only, not for multicast messages.
Configuration
Examples
Ruijie(config)# ipv6 hop-limit 100
Command Description Related
Commands
N/A N/A
Platform
Description
N/A
ipv6 nd dad attempts
Use this command to set the number of the NS packets to be continuously sent for IPv6 address