Ruijie RG-WLAN Series

Command Reference WIDS Commands
Configuration
Examples
#Configure attack detection in which the threshold for determining an authentication packet attack
within 10 seconds for different MAC addresses is 200.
Ruijie-AC(config)# ap-config ap-name
Ruijie-AC(config-ap)# flood-detect auth total number 200 time 10
Ruijie-AP(config)# wids
Ruijie-AP(config-wids ) flood-detect auth total number 200 time 10
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is supported on ACs and fat APs.
kickout threshold
Use this command to kick out the low-rate STA.
kickout threshold rate
Parameter
Description
Parameter Description
rate
Packet sending-receiving rate with the unit of M/Second.
Defaults
The low-rate STA is not filtered by default,
Command
mode
WIDS configuration mode.
Usage Guide
This command is used to filter the low-rate STA. When the wireless access end detects that the
sending-receiving rate of STA is less than the configured threshold, it disconnects the association.
Configuration
Examples
#Filter the STA with sending-receiving rate less than 30M/S
Ruijie(config)# wids
Ruijie(config-ac)# kickout threshold 30
Related
Commands
Command Description
wids
Enters WIDS configuration mode.
Platform
Description
N/A