Command Reference DHCP Snooping Commands
Configuration
Examples
The following is an example of enabling the check of the source MAC address of the DHCP request
message.
Ruijie# configure terminal
Ruijie(config)# ip dhcp snooping verify mac-address
Ruijie(config)# end
Ruijie# show ip dhcp snooping
Switch DHCP snooping status: ENABLE
Verification of hwaddr field status: ENABLE
DHCP snooping database write-delay time: 0 seconds
DHCP snooping option 82 status: ENABLE
DHCP Snooping Support Bootp bind status: ENABLE
Interface Trusted Rate limit (pps)
Related
Commands
Command Description
show ip dhcp snooping
View the configuration information of the DHCP
snooping.
Platform
Description
N/A.
show ip dhcp snooping
Use this command to view the setting of the DHCP snooping.
show ip dhcp snooping
Parameter
Description
Parameter Description
N/A. N/A.
Defaults
N/A.
Command
Mode
Privileged EXEC mode.
Usage Guide
N/A.
Configuration
Examples
Show the information of DHCP Snooping.
Ruijie# show ip dhcp snooping
Switch DHCP snooping status :ENABLE
Verification of hwaddr field status :DISABLE
DHCP snooping database write-delay time: 0 seconds
DHCP snooping option 82 status: ENABLE
To Next Page
Loading...
