Ruijie RG-WLAN Series Rgos Command Reference

Command Reference NFPP Commands
permanent
Permanent isolation.
Defaults
The default isolate time is 0, which means no isolation.
Command
Mode
NFPP configuration mode.
Usage Guide
The isolate period can be configured globally or based on the interface. For one interface, if the
isolate period is not set based on the interface, the global value shall be adopted; or the
interface-based isolate period shall be adopted.
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard isolate-period 180
Related
Commands
Command Description
nfpp dhcpv6-guard isolate-period
Set the isolate time on the interface.
show nfpp dhcpv6-guard summary
Show the configurations.
Platform
Description
N/A
dhcpv6-guard monitored-host-limit
Use this command to set the maxmum monitored host number.
dhcpv6-guard monitored-host-limit number
Parameter
Description
Parameter Description
number
The maximum monitored host number. The valid range is 1 to
4294967295.
Defaults
1000
Command
Mode
NFPP configuration mode
Usage Guide
If the monitored host number has reached the default 1000, the administrator shall set the
max-number smaller than 1000 and it will prompt the message that %ERROR:The value that you
configured is smaller than current monitored hosts 1000, please clear a part of monitored hosts. to
remind the administrator of the invalid configuration and removing the monitored hosts.
When the maximum monitored host number has been exceeded, it prompts the message that %
NFPP_ARP_GUARD-4-SESSION_LIMIT: Attempt to exceed limit of 1000 monitored hosts.to remind
the administrator.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English