Ruijie RG-WLAN Series Rgos Command Reference

Command Reference NFPP Commands
Defaults
By default, the attack threshold and the rate-limit threshold for each source IP address and each port
are the same. For the default rate-limit threshold value, see the icmp-guard rate-limit command.
Command
Mode
NFPP configuration mode.
Usage Guide
N/A.
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# icmp-guard attack-threshold per-src-ip 600
Ruijie(config-nfpp)# icmp-guard attack-threshold per-port 1200
Related
Commands
Command Description
nfpp icmp-guard policy
Show the rate-limit threshold and attack
threshold.
show nfpp icmp-guard summary
Show the configurations.
show nfpp icmp-guard hosts
Show the monitored host list.
clear nfpp icmp-guard hosts
Clear the monitored host.
Platform
Description
N/A
icmp-guard isolate-period
Use this command to set the isolate time globally.
icmp-guard isolate-period
{ seconds | permanent }
Parameter
Description
Parameter Description
seconds
Set the isolate time, in seconds. The valid range is 0, or 30 to 86400.
permanent
Permanent isolation.
Defaults
The default isolate time is 0, which means no isolation.
Command
Mode
NFPP configuration mode.
Usage Guide
The isolate period can be configured globally or based on the interface. For one interface, if the
isolate period is not set based on the interface, the global value shall be adopted; or the
interface-based isolate period shall be adopted.
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# icmp-guard isolate-period 180

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English