Ruijie RG-WLAN Series

Command Reference NFPP Commands
NFPP Commands
arp-guard attack-threshold
Use this command to set the global attack threshold. When the packet rate exceeds the attack
threshold, the attack occurs.
arp-guard attack-threshold { per-src-ip | per-src-mac | per-port } pps
Parameter
Description
Parameter Description
per-src-ip
Set the attack threshold for each source IP address.
per-src-mac
Set the attack threshold for each source MAC address.
per-port
Set the attack threshold for each port.
pps
Set the attack threshold, in pps. The valid range is 1 to 9999.
Defaults
By default, the attack threshold for each source IP address and source MAC address is 8pps; and the
attack threshold for each port is 200pps.
Command
Mode
NFPP configuration mode.
Usage Guide
The attack threshold shall be equal to or greater than the rate-limit threshold.
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard attack-threshold per-src-ip 2
Ruijie(config-nfpp)# arp-guard attack-threshold per-src-mac 3
Ruijie(config-nfpp)# arp-guard attack-threshold per-port 50
Related
Commands
Command Description
nfpp arp-guard policy
Show the rate-limit threshold and attack
threshold.
show nfpp arp-guard summary
Show the configurations.
show nfpp arp-guard hosts
Show the monitored host.
clear nfpp arp-guard hosts
Clear the isolated host.
Platform
Description
N/A