Command Reference EF-DHCP Commands
EF-DHCP Commands
central dhcp enable
Use this command to forward the DHCP packet through the wireless access controller in local
forwarding mode. Use the no form of this command to restore the default setting.
central dhcp enable
no central dhcp enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
By default, the DHCP packets are sent in local forwarding mode, namely the packets are forwarded
through the access point.
Command
mode
WLAN configuration mode
Usage Guide
Ruijie recommends enabling this function for easy management of the DHCP address pool in WLAN
and simplification of the DHCP topology.
Configuration
Examples
The following example enables this function.
Ruijie(config)#wlan-config 100 ruijie_wlan
Ruijie(config-wlan)#tunnel local
Ruijie(config-wlan)#central dhcp enable
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is supported only in RGOS10.4(1b19)p1, including RGOS10.4(1b19)p2.
This command is supported on access points and wireless access controllers.