Command Reference NTP Commands
Configuration
Examples
The following example enables NTP debugging.
Ruijie(config)# debug ntp
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
show ntp status
Use this command to show the NTP information.
Parameter
Description
Parameter Description
N/A N/A
Defaults
N/A
Command
Mode
Privileged mode
Usage Guide
If the NTP service of the system is enabled, the command shows existing NTP information. This
command will display no information until the synchronization server is added for the first time.
Configuration
Examples
The following example shows the existing NTP information of the system.
Ruijie# show ntp status
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
To Next Page
Loading...
