Ruijie RG-WLAN Series

Command Reference NFPP Commands
Description
nfpp dhcp-guard enable
Use this command to enable the DHCP anti-attack function on the interface.
nfpp dhcp-guard enable
Parameter
Description
Parameter Description
N/A N/A
Defaults
The DHCP anti-attack function is not enabled on the interface.
Command
Mode
Interface configuration mode.
Usage Guide
The interface DHCP anti- attack configuration is prior to the global configuratio
Configuration
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp dhcp-guard enable
Related
Commands
Command Description
dhcp-guard enable
Enable the anti-ARP attack function.
show nfpp dhcp-guard summary
Show the configurations.
Platform
Description
N/A
nfpp dhcp-guard isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp dhcp-guard isolate-period
{ seconds | permanent }
Parameter
Description
Parameter Description
seconds
Set the isolate period, in second. The valid range is 0, or [30, 86400].
0 indicates no isolation.
permanent
Permanent isolation.
Defaults
By default, the isolate period is not configured
Command
Interface configuration mode.