Command Reference Link Checking Commands
Description
num
Specifies the ID of the scheduling session to be created or to be
applied to a WLAN. The range is from 1 to 64.
no
Deletes the scheduling session or
cancels the ID (in the range from 1 to 64) of the scheduling session
applied to a WLAN.
Defaults
No scheduling session is configured by default.
No scheduling session is applied to a WLAN by default.
Command
mode
Global configuration mode
or WLAN configuration mode on fit AP networking topology
Usage Guide
In global configuration mode, you can use this command to create a scheduling session and
configure parameters for it. If the scheduling session has been created, the configuration is invalid.
On fit AP networking topology, the scheduling session created in WLAN configuration mode will be
applied to a WLAN.
Configuration
Examples
The following example creates or configures scheduling session 1.
Ruijie(config)# schedule session 1
The following example deletes scheduling session 1.
Ruijie(config)#no schedule session 1
The following example applies scheduling session 1 to WLAN 1 on fit AP networking topology.
Ruijie(config)# wlan-config 1
Ruijie(config-wlan)# schedule session 1
The following example deletes scheduling session 1 from WLAN 1 on fit AP networking topology.
Ruijie(config)# wlan-config 1
Ruijie(config-wlan)# no schedule session 1
Related
Commands
Command Description
show schedule session
Checks configuration information about the
scheduling session.
show running-config
Checks current configuration information.
Platform
Description
This command is supported only on wireless AC and fat AP series.
schedule session period/time
Use this command to set a scheduling period for a scheduling session. Use the no form of this
command to delete the configuration.
schedule session num time-range time-range period day1 [to day2] time hh1:mm1 [to
hh2:mm2]
To Next Page
Loading...
Need help?
General
