Ruijie RG-WLAN Series - Wlan-Qos Wlan-Based

Command Reference WLAN QoS Commands
no
Restores the traffic limit to the default value.
Defaults
No traffic limit is set by default.
Command
mode
Configuration mode.
N/A
Usage Guide
Configuration
Examples
Example 1: Set the average in-band rate to 800Kbps and burst rate to 1600Kbps for the user
0000.0000.0001 in WLAN 1.
Ruijie(config)# wlan-qos netuser 0000.0000.0001 inbound average-data-rate 800
burst-data-rate 1600
Related
Commands
Command Description
wlan-qos wlan-based { wlan-id | ssid }
{ per-user-limit | total-user-limit}
{ down-streams | up-streams }
average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the WLAN-based in-band and
out-of-band traffic rate limits.
wlan-qos ap-based { per-user-limit |
total-user-limit } { down-streams | up-streams }
average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the AP-based in-band and
out-of-band traffic rate limits.
Platform
Description
This command is supported on fat APs.
wlan-qos wlan-based
Use this command to configure the upstream and downstream traffic limit of the current WLAN.
Use the no form of this command to restore the default value.
wlan-qos wlan-based { wlan-id | ssid } { per-user-limit | total-user-limit } { down-streams |
up-streams } average-data-rate average-data-rate burst-data-rate burst-data-rate
no wlan-qos wlan-based { wlan-id | ssid } { per-user-limit | total-user-limit } { down-streams |
up-streams }
Parameter
Description
Parameter Description
wlan-id
WLAN ID
ssid
SSID configured by the WLAN
per-user-limit
Limit for each user on the WLAN