Ruijie RG-WLAN Series

Command Reference WLAN QoS Commands
Defaults
No traffic limit is set by default.
Command
mode
Configuration mode.
Usage Guide
N/A
Configuration
Examples
Example 1: Configure the average downstream rate of AP wlan-ap-001 to 800Kbps and burst rate to
1600Kbps.
Ruijie(config)# wlan-qos ap-based per-user-limit down-streams
average-data-rate 800 burst-data-rate 1600
Related
Commands
Command Description
wlan-qos netuser mac-address { inbound |
outbound } average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the Client-based in-band and
out-of-band traffic rate limits.
wlan-qos wlan-based { wlan-id | ssid }
{ per-user-limit | total-user-limit }
{ down-streams | up-streams }
average-data-rate average-data-rate
burst-data-rate burst-data-rate
Configures the WLAN-based in-band and
out-of-band traffic rate limits.
Platform
Description
This command is supported on fat APs.
wlan-qos netuser
Use this command to configure the in-band and out-of-band traffic limits for a specified user in the
current WLAN.
Use the no form of this command to restore the default value.
wlan-qos netuser mac-address { inbound | outbound } average-data-rate average-data-rate
burst-data-rate burst-data-rate
no netuser mac-address { inbound | outbound }
Parameter
Description
Parameter Description
mac-address
User's MAC address to be set
inbound
User’s in-band traffic limit
outbound
User’s out-of-band traffic limit
average-data-rate
average-data-rate
Average rate limit, ranging from 1 to 819200 in 8Kbps
burst-data-rate
burst-data-rate
Burst rate limit, ranging from 1 to 819200 in 8Kbps