Ruijie RG-WLAN Series

Command Reference TACACS+ Commands
server(TACACS+)
Use this command to configure server address in TACACS+ group server.
server { ip-address | ipv6-address }
no server { ip-address | ipv6-address }
Parameter
Description
Parameter Description
ip-address
The IP address of the server in the TACACS+ server group
ipv6-address
The IPv6 address of the server in the TACACS+ server group
Defaults
N/A
Command
Mode
TACACS+ group server configuration mode.
Usage Guide
You must enter the TACACS+ server group configuration mode to configure this command.
To configure server addresses in a TACACS+ group server, you must execute the tacacs-server
host command in global configuration mode.
For the IP address of the servers in TACACS+ group servers, when one server does not reply, it will
send the request to the next server.
Configuration
Examples
The following example configures a TACACS+ server group named tac1 and a TACACS+ server
address 1.1.1.1 in this group:
Ruijie(config)#aaa group server tacacs+ tac1
Ruijie(config-gs-tacacs+)#server 1.1.1.1
Related
Commands
Command Description
aaa group server tacacs+
Configures a TACACS+ server group.
ip vrf forwarding
Configures a VRF name supported by
TACACS+ server group.
Platform
Description
N/A
show tacacs
Use this command to show the interoperation of each TACACS+ server.
show tacacs+
Parameter
Description
Parameter Description