Ruijie RG-WLAN Series

Command Reference TACACS+ Commands
Configuration
Examples
The following example specifies TACACS+ packet to obtain ip address from fastEthernet 0/0 as the
source IP address of TACACS+ packets:
Ruijie(config)# ip tacacs source-interface fastEthernet 0/0
Related
Commands
Command Description
tacacs-server host
Defines a TACACS+ server.
ip address
Configures the ip address of the interface.
Platform
Description
This command is not supported on AP110-W.
ip vrf forwarding(TACACS+)
Use this command to configure vrf name used by the TACACS+ group server (this command is
supported by the device supporting VRF).
ip vrf forwarding vrf-name
no ip vrf forwarding
Parameter
Description
Parameter Description
vrf-name
VRF name.
Defaults
N/A
Command
Mode
TACACS+ group server configuration mode.
Usage Guide
Specify vrf name to the specified TACACS+ server.
Configuration
Examples
The following example specifies VRF name as vpn1 to TACACS+ server group:
Ruijie(config)# aaa group server tacacs+ tac1
Ruijie(config-gs-tacacs+)# server 1.1.1.1
Ruijie(config-gs-tacacs+)# ip vrf forwarding vpn1
Related
Commands
Command Description
aaa group server tacacs+
Configures a TACACS+ server group.
server
Configures the server list of aTACACS+ server
group.
Platform
Description
N/A