Command Reference NFPP Commands
Description
ip
Set the IP address.
mask
Set the IP mask.
all
Delete the configurations of all trusted hosts.
Defaults
N/A.
Command
Mode
NFPP configuration mode.
Usage Guide
The administrator can use this command to set the trusted host free from monitoring. The ICMP
packets are allowed to sent to the trusted host CPU without any rate-limit and warning configuration.
Configure the mask to set all hosts in one network segment free from monitoring.
UP to 500 trusted hosts are supported.
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# ip-guard trusted-host 1.1.1.0 255.255.255.0
Related
Commands
Command Description
show nfpp ip-guard trusted-host
Show the configurations.
Platform
Description
N/A
log-buffer entries
Use this command to set the NFPP log buffer area size.
log-buffer entries number
Parameter
Description
Parameter Description
number
The buffer area size. The valid range is 0 to 1024.
Defaults
256.
Command
Mode
NFPP configuration mode.
Usage Guide
N/A
Configuration
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# log-buffer entries 50