Ruijie RG-WLAN Series Rgos Command Reference

Command Reference IPv6 Commands
collision check on the interface. Use the no form of this command to restore it to the default setting.
ipv6
no
Parameter Description Parameter
Description
value
Number of the NS packets. If it is set to 0, it indicates that the IPv6
address collision check is disabled on the interface. The range is 0 to 600.
Defaults
1.
Command
Mode
Interface configuration mode.
Usage Guide
When the interface is configured with a new IPv6 address, the address collision shall be checked
before the address is assigned to the interface, and the address shall be in the ”tentative” status. After
the address collision check is completed, if no collision is detected, the address can be used
normally; if collision is detected and the interface ID of the address is an EUI-64 ID, it indicates that
the link-layer address is repeated, and the system will automatically shut down the interface (that is,
to prohibit IPv6 operations on the interface). In this case, you shall modify and configure a new
address manually, and restart address collision check for the down/up interface. Whenever the state
of an interface changes from down to up, the address collision check function of the interface will be
enabled.
Configuration
Examples
Ruijie(config-if)# ipv6 nd dad attempts 3
Command Description Related
Commands
show ipv6 interface
Show the interface information.
Platform
Description
N/A
ipv6 nd managed-config-flag
Use this command to set the “managed address configuration” flag bit of the RA message. Use the
no form of this command to remove the setting.
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Parameter Description Parameter
Description
N/A N/A
Defaults
None.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English