Command Reference Spectral Analysis Commands
Description
num
Configures the scanning cycle within the range from 1 to 100. The
unit of the cycle is 5 microseconds.
Defaults
5 microseconds
Command
mode
AP configuration mode on the fit AP or AC
Or:
Spectral configuration mode on the fat AP
Usage Guide
N/A
Configuration
Examples
This example shows how to configure the SA scanning cycle of the specified AP.
Ruijie(config-ap)# spectral period 10
This example shows how to restore the scanning cycle of the specified AP to the default value.
Ruijie(config-ap)# no spectral speriod
Related
Commands
Command Description
N/A N/A
Platform
Description
This command is supported on all wireless AC products and several AP products, including
AP220-SH v1.0 v1.1, AP320－I, AP330－I, AP110-W, AP220－I v2.0, AP220-E v5.0.
To Next Page
Loading...
