Command Reference LINE Commands
input command to restore the setting to the default value.
Command
Mode
Line configuration mode.
Usage Guide
This command is used to set the protocols in the Line mode that are available for
communication. By default, VTY allows all the protocols for communication. After protocols
available for communication are set, only these protocols can connect on the specific VTY
successfully. Use the show running command to view configuration information under Line.
Note: You can restore the default configuration by using the default transport input
command. The no transport input command is used to disable all the communication
protocols in the LINE mode. The setting result is the same as that of transport input
none.
Configuration
Examples
Specify that only the Telnet protocol is allowed to login in line vty 0 4:
Ruijie# configure terminal
Ruijie(config)# line vty 0 4
Ruijie(config-line)# transport input telnet
Related
Commands
Command Description
show running
Shows status information
Platform
Description
To Next Page
Loading...
Need help?
General
