Ruijie RG-WLAN Series Rgos Command Reference

Command Reference Interface Commands
counters
The counters on the interface.
description
The description of the interface, including the link status.
status
All the link status of the Layer 2 interface, including the rate and
duplex.
switchport
Layer 2 interface information.
trunk
Trunk port, applicable for physical port and aggregate port.
transceiver
Basic optical module information.
alarm
Alarm information of the optical module. The “None” is displayed
when no fault exists.
diagnosis
Diagnosis parameter value of the optical module.
line-detect
Line detecting status of the port.
mtu
Show the value of MTU on the interface.
usage
Show the bandwidth usage of the interface.
Defaults
Show all the information.
Command
Mode
Privileged EXEC mode.
Usage Guide
Show the basic information if no parameter is specified.
The functions of showing the optical module information, alarming the fault and diagnosing the
parameters shall be used combining with the optical module of the RG network.
To show the optical module and alarm the fault and diagnose the parameters, the function of Digital
Diagnostic Monitoring must be supported by the optical module.
Configuration
Examples
The follow example shows the interface information when the Gi0/1 is Trunk port:
SwitchA#show interfaces gigabitEthernet 0/1
Index(dec):1 (hex):1
GigabitEthernet 0/1 is DOWN , line protocol is DOWN
Hardware is Broadcom 5464 GigabitEthernet
Interface address is: no ip address
MTU 1500 bytes, BW 1000000 Kbit
Encapsulation protocol is Bridge, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
RXload is 1 ,Txload is 1
Queueing strategy: FIFO
Output queue 0/0, 0 drops;
Input queue 0/75, 0 drops
Switchport attributes:
interface's description:""
medium-type is copper
lastchange time:0 Day: 0 Hour: 0 Minute:13 Second
Priority is 0

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English