Command Reference Interface Commands
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
0 packets output, 0 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
The following example shows the layer-2 information of the Gi0/1.
Ruijie# show interfacesgigabitEthernet 0/1 switchport
Interface Switchport ModeAccess Native Protected VLAN lists
--------- ---------- --------- ------ ------ ---------
GigabitEthernet 0/1 enabled Access 11 Disabled ALL
The following example shows the MTU information on the interface GigabitEthernet 1/1.
Ruijie#show interfaces GigabitEthernet 1/1 mtu
interface MTU
------------------- -------
GigabitEthernet 1/1 1500
The following example shows the bandwidth usage on the interface GigabitEthernet 1/1.
Ruijie#show interfaces GigabitEthernet 1/1 usage
Interface Bandwidth Bandwidth Usage
------------------- --------------- ----------------
GigabitEthernet 1/1 1,000,000 Kbit 20%
Related
Commands
Command Description
duplex
Duplex
flowcontrol
Flow control status.
interface gigabitEthernet
Select the interface and enter the interface
configuration mode.
interface aggregateport
Create or access the aggregate port, and enter
the interface configuration mode.
interface vlan
Create or access the switch virtual interface
(SVI), and enter the interface configuration
mode.
shutdown
Disable the interface.
speed
Configure the speed on the port.
switchport priority
Configure the default 802.1q interface priority.
switchport protected
Specify the interface as a protected port.
Platform
Description
N/A