Command Reference DHCP Commands
type
Uses the string definition or digits definition to indicate the hardware
platform protocol of the DHCP client,:
String options:
Ethernet
ieee802
Digits options:
1 (10M Ethernet)
6 (IEEE 802)
Defaults
No hardware address is defined by default.
If there is no option when the hardware address is defined, it is Ethernet by default.
Command
Mode
DHCP address pool configuration mode
Usage Guide
This command can be used only when the DHCP is defined by manual binding.
Configuration
Examples
The following example defines the MAC address 00d0.f838.bf3d with the type ethernet.
Ruijie(dhcp-config)# hardware-address 00d0.f838.bf3d
Command Description
client-identifier
Defines the unique ID of the DHCP client (Indicated in hexadecimal
separated by dot).
Related
Commands
host
Defines the IP address and network mask, which is used to configure
the DHCP manual binding.
ip dhcp pool
Defines the name of the DHCP address pool and enters DHCP
address pool configuration mode.
Platform
Description
N/A
host
Use this command to define the IP address and network mask of the DHCP client host in DHCP
address pool configuration mode. Use the no form of this command to delete the definition of the IP
address and network mask for the DHCP client.
host ip-address [ netmask ]
no host
Parameter Description
ip-address
Defines the IP address of DHCP client.
Parameter
Description
netmask
Defines the network mask of DHCP client.
Defaults
No IP address or network mask of the host is defined by default.
To Next Page
Loading...
Need help?
General
