Command Reference IPv6 Commands
RA timer is stopped (on) Indicate whether the RA timer is started.
waits
Indicate that the RS is received but the number of the responses is
not available.
initcount Indicate the number of the RAs when the RA timer is restarted.
RA(out/in/ inconsistent)
out: Indicate the number of the RAs that are sent.
In: Indicate the number of the RAs that are received.
inconsistent: Indicate the number of the received RAs in which the
parameters are different from those contained in the RAs advertised
by the device.
RS(input) Indicate the number of the RSs that are received.
Link-layer address Link-layer address of the interface.
Physical MTU Link MTU of the interface.
!M | M
!M indicates the managed-config-flag bit in the RA is not set.
M: Conversely
!O | O
!O indicates the other-config-flag bit in the RA is not set.
O: Conversely
Description of the fields of the prefix list in ra-info:
Field Meaning
total The number of the prefixes of the interface.
fec0:1:1:1::/64 A specific prefix.
Def Indicate that the interfaces use the default prefix.
Auto | CFG
Auto: Indicate the prefix is automatically generated after the
interface is configured with the corresponding IPv6 address. CFG:
Indicate that the prefix is manually configured.
!Adv Indicate that the prefix will not be advertised.
vltime Valid lifetime of the prefix, measured in seconds.
pltime Preferred lifetime of the prefix, measured in seconds.
L | !L
L: Indicate that the on-link in the prefix is set.
!L: Indicate that the on-link in the prefix is not set.
A | !A
A: Indicate that the auto-configure in the prefix is set. !A: It indicates
that the auto-configure in the prefix is not set.
Command Description Related
Commands
N/A N/A
Platform
Description
N/A
To Next Page
Loading...
Need help?
General
