HEIDENHAIN iTNC 530 HSCI - Page 1732

1732 HEIDENHAIN Technical Manual iTNC 530 HSCI
TT touch probe for tool measurement
350 20 1 Center in 1st axis
2 Center in 2nd axis
3 Center in 3rd axis
21 – Effective radius
22 1 Probing position 1 in axis X
2 Probing position 1 in axis Y
3 Probing position 1 in axis Z
23 1 Probing position 2 in axis X
2 Probing position 2 in axis Y
3 Probing position 2 in axis Z
24 1 Probing position 3 in axis X
2 Probing position 3 in axis Y
3 Probing position 3 in axis Z
25 1 Probing position 4 in axis X
2 Probing position 4 in axis Y
3 Probing position 4 in axis Z
Datum from touch probe cycle
360 1 1 to 9
(X, Y, Z, A, B, C,
U, V, W)
Last datum of a manual touch probe
cycle, or last touch point from Cycle 0
without compensation of stylus
length, but with compensation of
stylus radius (workpiece coordinate
system)
21 to 9
(X, Y, Z, A, B, C,
U, V, W)
Last reference point of a manual
touch probe cycle, or last touch point
from Cycle 0 without stylus length or
stylus radius compensation (machine
coordinate system)
3 – Measurement result of touch probe
cycles 0 and 1 without probe radius or
length compensation
370 6 – Measurement result on the screen
Read values from active datum table
500 Line Column Read ACTUAL values (MP7475 = 0)
501 Line Column Read REF values (MP7475 = 1)
505 1 – 0 = no datum table selected
1 = datum table selected
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum