HEIDENHAIN iTNC 530 HSCI - Page 496

496 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP118.x Position encoder input for axes
Format: %xxxx
Input: Bit 0: Position encoder input 1 V
PP
0: 1 V
PP
1: Reserved
Bit 1: Terminating resistor for encoder signal line
0: Active
1: Deactivated
Bit 2: Input frequency of the position encoder input at 1 V
PP
:
0: 27 kHz
1: 400 kHz
Bit 3: Analog or digital position encoder input:
0: Analog encoder signal control (1 V
PP
)
1: Digital encoder signal control (EnDat 2.2)
Bit 4: Reserved
Function is not yet supported.
Bit 5: Reserved
Function is not yet supported.
60642x-03
608
MP119.x Position encoder input for the spindle/spindles
Format: %xxxx
Input: Bit 0: Position encoder input 1 V
PP
0: 1 V
PP
1: Reserved
Bit 1: Terminating resistor for encoder signal line
0: Active
1: Deactivated
Bit 2: Input frequency of the position encoder input at 1 V
PP
:
0: 27 kHz
1: 400 kHz
Bit 3: Analog or digital position encoder input:
0: Analog encoder signal control (1 V
PP
)
1: Digital encoder signal control (EnDat 2.2)
Bit 4: Reserved
Function is not yet supported.
Bit 5: Reserved
Function is not yet supported.
60642x-03
608
MP120.x Nominal speed command outputs of the axes
Input: 0: No servo-controlled axis
1 to 8: Analog CMA output X66, X67
51 to 56: Digital CC outputs X51 to X56
80 to 85: Digital UEC outputs X80 to X85
RESET 615
MP Function and input Software
version and
behavior
Page