HEIDENHAIN iTNC 530 HSCI - Page 545

July 2013 4.4 List of machine parameters 545
MP7237 Display and reset the operating times PLC
RUN
1170
MP7237.0 Display PLC operating times
Input:
Bits 0 to 12 represent PLC operating times 1 to 13
0: Do not display
1: Display
MP7237.1 Reset PLC operating times with code number 857282
Input: Bits 0 to 12 represent PLC operating times 1 to 13
0: Do not reset
1: Reset
MP7237.2 Reset NC operating times with code number 857282
Input: Bit 0 – No function
Bit 1 – "Machine on" operating time
Bit 2 – "Program run" operating time
0: Do not reset
1: Reset
MP7238.0-12 Dialog messages for PLC operating times 1 to 13
Input: 0 to 4095
Dialog no. from the file (OEM.SYS)
PLC
RUN
1170
MP7245 Disable auxiliary cycles and Cycle 32
Input: Bit 0 – Auxiliary cycles (18, 33)
0: Auxiliary cycles disabled
1: Auxiliary cycles 18, 33 enabled
Bit1 – Cycle 32
0 = Cycle 32 enabled
1 = Cycle 32 disabled
PLC
RUN
1258
MP7246 Machine parameter with multiple function
Input: %xxxx
Bit 0 – Paraxial positioning blocks
0: Permitted
1: Disabled
Bit 1 – Clear with DEL key
0: Does not need confirmation
1: Must confirm via soft key
Bit 2 – Tool usage file
0: Do not generate
1: Generate
Bit 3 – Settings file for AFC
0: Do not generate
1: Generate
Bit 4 – ASCII file for machining time per NC block
0: Do not create ASCII file for machining time per NC block
1: Create ASCII file for machining time per NC block
PLC
RUN
1212,
1264,
1597
MP7251 Number of global Q parameters starting from Q99 (up to
Q60) that are transferred from the OEM cycle to the calling
program.
Input: 0 to 40
PLC
RUN
1715
MP Function and input Software
version and
behavior
Page