July 2013 4.4 List of machine parameters 577
MP7682 Machine parameter with multiple function
Format: %xxxxxxxxxxxxxxx
Input: Bit 0 – Incremental block after TOOL CALL
0: With length compensation
1: Without length compensation
Bit 1 – Reference value for calculating the preset during
datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with modulo display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 – Reserved, enter 0
Bit 4 – Tolerance for compensating movements with tilting
axes (M114)
0: Tolerance will be included
1: Tolerance will not be included
Bit 5 – Feed rate with M128 or TCPM
0: Feed rate refers to tool tip
1: Feed rate from interpolation of all axes involved
Bit 6 – Behavior with TOOL DEF strobe
0: Depending on the NC program, the TOOL DEF strobe
must be acknowledged by the PLC (TOOL DEF
within a continuous contour)
1: TOOL DEF strobe must always be acknowledged by the
PLC
Bit 7 – Block elements TOOL CALL and S in ISO blocks
0: Machine as programmed
1: Machine at beginning of block (block display does not
change)
Bit 8 – Behavior of M8 at the end of Cycles 202 and 204
0: At the end of Cycles 202 and 204, the status of M8 is
restored to that before the cycle call (behavior
until now).
1: At the end of Cycles 202 and 204, the status of M8 is not
restored automatically.
PLC
RUN
1148,
1149,
1216,
769,
1604
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
