HEIDENHAIN iTNC 530 HSCI - Page 578

578 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7682 Bit 9 – Loading of "Tilted working plane" status
0: The "tilted working plane" status is not applied to the
Manual Operation mode after a program
interruption (behavior until now).
1: The "Tilted working plane" status is loaded into the
Manual Operation mode after a program
interruption
Bit 10 – Peripheral milling active/inactive
0: Peripheral milling allowed
1: Peripheral milling inactive
Bit 11 – Reserved
Bit 12 – Error message "Tool radius too large" is suppressed
if R2 > R
0: Error message is displayed
1: Error message is suppressed
Bit 13 – No program interruption upon invalid TOOL DEF
0: Error message and NC stop upon invalid TOOL DEF
1: Only warning upon invalid TOOL DEF
Bit 14 – No insertion of the tool if TIME2 has expired
0: Tool is inserted even if TIME2 has expired
1: TOOL CALL for a tool where TIME2 has expired leads to
an error message and NC stop
Bit 15 – Reserved = 0
Bit 16 – Reserved = 0
Bit 17 – Reserved = 0
1264,
1595
MP Function and input Software
version and
behavior
Page