HEIDENHAIN iTNC 530 HSCI - Meaning of the machine parameters

July 2013 4.4 List of machine parameters 579
MP7683 Executing pallet tables and NC programs
Format: %xxxxxxxxx
Input: Bit 0 – No function
Bit 1 – Program Run, Full Sequence mode
0: NC start executes a complete NC program.
1: NC start executes all NC programs up to the next pallett.
Bit 2 – Program Run, Full Sequence mode
0: As defined in bit 1
1: All NC programs and pallets up to the end of the table are
executed.
Bit 3 – When the end of the table is reached, the process
begins again with the first line.
0: Function is not in effect
1: Function is effective (bit 2 = 1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot be edited.
1: In the Program Run, Full Sequence and Program Run,
Single Block modes, the current pallet table can
be edited.
Bit 5 – AUTOSTART soft key
0: Do not display soft key
1: Display soft key
Bit 6 – Display of pallet table and NC program
0: Both simultaneously in a split screen
1: Pallet table or NC program individually
Bit 7 – AUTOSTART function
0: AUTOSTART function by NC
1: AUTOSTART function by PLC
Bit 8 – Procedure for tool-oriented machining in the Program
Run operating modes
0: NC start machines all workpieces on the pallet until the
next tool change
1: NC start executes all NC programs until the end of the
pallet
PLC
RUN
1215,
1496
MP7683 Executing pallet tables and NC programs
Bit 9 – EDIT PALLET soft key
0: EDIT PALLET soft key is not displayed
1: EDIT PALLET soft key is displayed
PLC
RUN
1215,
1496
MP Function and input Software
version and
behavior
Page