HEIDENHAIN iTNC 530 HSCI - Page 601

July 2013 5.2 Overview of markers and words 601
W 1022 Error status of the last called PLC module NC NC –
W 1024/1100
a
Axis enabling NC NC 844
W 1026/1104
a
Axes in position NC NC 900
W 1028/1108
a
Axes in motion NC NC 901
W 1030/1112
a
Current direction of traverse NC NC 609
W 1032/1116
a
Reference marks not yet traversed NC NC 803
W 1034/1120
a
Positive software limit switch was
approached
NC NC 628
W 1036/1124
a
Negative software limit switch was
approached
NC NC 628
W 1038/1128
a
Prepare to open the position control loop PLC PLC 845
W 1040/1132
a
Axis-specific opening of the position control
loop
PLC PLC 845
W 1042/1136
a
Deactivation of monitoring functions PLC PLC 894
W 1044/1140
a
Actual-to-nominal value transfer PLC PLC 847
W 1046/1144
a
Manual traverse in positive direction PLC PLC 1404
W 1048/1148
a
Manual traverse in negative direction PLC PLC 1404
W 1050/1152
a
Incremental jog positioning in positive
direction
PLC PLC
W 1052/1156
a
Incremental jog positioning in negative
direction
PLC PLC
W 1054/1160
a
Reference end position PLC PLC 803
W 1056/1164
a
Lubrication pulse: Value in MP4050.x
exceeded
NC NC 629
W 1058/1168
a
Reset the accumulated distance PLC PLC 629
W 1060/1172
a
Axis-specific feed-rate enable PLC PLC 846
W 1062/1174
a
Lock the handwheel for specific axes PLC PLC 1507
a. Depending on the active PLC module interface MP4020 bit 14
Marker Description Set Reset SW
version
Page