HEIDENHAIN iTNC 530 HSCI - Page 600

600 HEIDENHAIN Technical Manual iTNC 530 HSCI
W 516 Q no. 0-7 for numerical data transfer
PLC to NC
PLC PLC 1714
B 518 Definition of the free rotation function PLC PLC 1154
B 519 Traverse direction for free rotation PLC PLC 1154
W 522 Enabling the fast PLC inputs PLC PLC 1753
W 524 Open the position control loop, deactivate
the monitoring functions if drive enabling via
PLC input from MP4132 is missing
PLC PLC 863
D 528 Double word with multiple function; here
data for transfer from PLC to NC
PLC PLC 1714
D 528 - 544 Target position for PLC positioning PLC PLC 646
D 528 - 544 Datum shift for axes 1 to 5 PLC PLC 1534
W 560 - 568 Feed rate for PLC positioning PLC PLC 646,
1154
W 576 - 584 Lag-tracking axis error compensation PLC PLC 659
D 592 Nominal position for spindle orientation PLC PLC 973
D 596 Max. feed rate from PLC [mm/min] NC/
PLC
PLC 842
D 604 Maximum possible spindle speed PLC NC/
PLC
952
W 632 Alternative control input variable for AFC PLC NC/
PLC
1222
W 754 % function for feed-rate override for free
rotation
PLC PLC 1154
D 756 Programmed rotational speed or rotational
speed from the PLC [0.001 min
–1
]
NC/
PLC
NC/
PLC
960
D 760 Offset in tilting axes touch probe center
offset [1/10 000°]
PLC PLC 1544
W 764 Percentage for spindle speed override (PLC
to NC)
NC/
PLC
NC/
PLC
963
W 766 Percentage for feed-rate override (PLC to
NC)
NC/
PLC
NC/
PLC
1156
D 768 - 956 Value from MP4210.0 to MP4210.47 NC NC 1737
W 960 - 968 Value from MP4220.0 to MP4220.4 NC NC 1738
W 976 - 994 Value from MP4310.0 to MP4310.9 NC NC 1738
W 1002 Last PLC run-time error that occurred NC NC 1754
W 1004 Error number of the last NC error message
that occurred
NC NC –
W 1008 S code for minimum speed NC NC 965
W 1016 PLC module that was last processed
incorrectly
NC NC –
W 1018 Number of files opened by the PLC NC NC 1408
W 1020 Number of all open files NC NC 1408
Marker Description Set Reset SW
version
Page