HEIDENHAIN iTNC 530 HSCI - Page 706

706 HEIDENHAIN Technical Manual iTNC 530 HSCI
Step 6
 Probe surface Y2
 Set Y = 0
Step 7
 Position C to 180
 Probe surface Y2
 ΔY2 = determined value
 Z1 = ΔY2 – probe length + ball radius
 Entry for the kinematics if the results differ for
• <Line no. [0] Column COORD> and Z1, then COORD = 0.5 * (<Line no. [0] Column COORD> + Z)