IBM TS3310

8-125. Operator Panel Cable Connectors 8-114
8-126. Four screws on front of door and plastic
cable guide ...........8-115
8-127. Hex stand-off behind the Cable Spool
Assembly ...........8-116
8-128. Backplane Connector Board (BCB), Rear
View.............8-117
8-129. Drive Sled Interface Board (DSIB), Side
Cover Removed .........8-117
8-130. D-shell connectors and flat cables, side
cover removed ..........8-119
8-131. Drive power overload fuse cover plate 8-120
8-132. Drive power overload fuse......8-120
8-133. Foot pad Locations ........8-122
8-134. Removing the cover from the internal
drive .............8-124
8-135. Using hex wrench to rewind tape into
cartridge ............8-125
8-136. Drive with cover removed to reveal gear
train .............8-126
8-137. Using hex wrench to rewind tape into
cartridge ............8-127
8-138. Leader Block Assembly (LBA) 8-128
8-139. Using hex wrench to rewind tape into
cartridge ............8-129
8-140. Using hex wrench to rewind tape into
cartridge ............8-130
8-141. Drive with cover removed to reveal gear
train. .............8-131
8-142. Leader Block Assembly (LBA) 8-132
8-143. Using hex wrench to rewind tape into
cartridge ............8-133
8-144. Drive with cover removed to reveal gear
train. .............8-134
8-145. Leader Block Assembly (LBA) 8-135
10-1. Types of Power Cord Receptacles 10-4
D-1. Front panel of the drive .......D-1
D-2. Inserting a cartridge into the drive D-5
D-3. The IBM LTO Ultrium Data Cartridge D-6
D-4. Ultrium Data Cartridge on the left; WORM
Cartridge on the right ........D-8
D-5. Sample bar code label on the LTO Ultrium
4 Tape Cartridge .........D-11
D-6. Checking for gaps in the seams of a
cartridge ............D-15
D-7. Tape cartridges in a Turtlecase D-16
D-8. Double-boxing tape cartridges for
shipping ............D-16
D-9. Leader pin in the incorrect and correct
positions ............D-20
D-10. Placing the dislodged leader pin into the
correct position ..........D-21
D-11. Rewinding the tape into the cartridge D-21
D-12. Leader Pin Reattachment Kit .....D-22
D-13. Attaching the leader pin attach tool to the
cartridge ............D-23
D-14. Winding the tape out of the cartridge D-24
D-15. Removing the C-clip from the leader pin D-24
D-16. Attaching the leader pin to the tape D-25
E-1. AIX ERRPT Library Error Log Example E-2
E-2. AIX ERRPT Drive Error Log Example E-3
E-3. Example of Error Suggesting SCSI Bus
Problem, Which Takes Down Entire Bus . . E-4
E-4. SCSI Problem Points to Library Control
Path as Possible Cause ........E-5
E-5. AIX ERRPT Commands Error Log Example E-6
Figures xv