Beta Draft Confidential
3-441/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring CBX or GX Logical Ports
Setting Logical Port Attributes
6. Select a traffic descriptor from the list for forward Trunk Signaling traffic and
choose OK to return to the Add Logical Port dialog box.
7. Choose Select for Trunk Signaling Reverse. The Trunk Signaling Reverse Traffic
Descriptor dialog box appears (Figure 3-17).
Figure 3-17. Trunk Signaling Reverse Traffic Descriptor Dialog Box
8. Select a traffic descriptor from the list for reverse Trunk Signaling traffic and
choose OK to return to the Add Logical Port dialog box.
To complete this trunk logical port configuration, do one of the following:
• If this is an OPTimum Trunk logical port, continue with the next section,
“OPTimum Trunk VPI Range Attributes.”
• If this is a Direct Trunk logical port, proceed to “Completing the Logical Port
Configuration” on page 3-57.
Note – To define a new traffic descriptor, see “Defining Network-wide TDs” on
page 12-8.
To Next Page
Loading...
Need help?
General
