Lucent Technologies CBX 3500 - Configuring PMP PVC Root Parameters

Beta Draft Confidential
10-761/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring ATM PVCs
Configuring PMP Circuits
Configuring PMP PVC Root Parameters
To configure point-to-multipoint PVC root parameters, you enter information in each
of the following tabs, categorized by parameter type:
• Administrative
•Traffic Type
• NDC
• Accounting
Before You Begin
Before you configure the parameters for a PMP PVC root, you must select the PMP
PVC root endpoint. If you are creating a PMP PVC root from an LPort instance node,
you do not need to select an endpoint. Continue with step 1 below.
See the following for instructions on selecting PMP PVC endpoints:
• “Selecting an Endpoint From a Switch” on page 10-74
• “Selecting an Endpoint From a Physical Port” on page 10-75
To configure PMP PVC root parameters:
1. In the Add Point-to-Multipoint PVC Root dialog box, select the Administrative
tab (Figure 10-22).
Figure 10-22. Add Point-to-Multipoint PVC Root: Administrative Tab
2. Complete the fields in the Administrative tab, as described in Table 10-15.