Beta Draft Confidential
7-461/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring Trunks
Adding an External Device Object to the Network
3. For the modifications to be saved, you must disable editing.
a. From the Edit menu select Disable Editing.
b. When asked to confirm, choose Yes to save the changes or No to disable
editing without saving any changes.
Displaying a Connection on the Map
A connection can be shown between objects on the map. This is for display purposes
only and does not show the actual status of the connection.
To show a connection between objects on the map:
1. On the network map, verify that editing is enabled by viewing the Edit menu. If it
is enabled, the first menu selection will be Disable Editing. If it is not enabled,
from the Network Map View window, select Edit
⇒ Enable Editing.
2. On the Edit menu, select Create.
3. Select Connector.
4. Select Simple.
5. Select the PSAX node on the map by left clicking the mouse, then release the
mouse button after dragging the connector line to the destination switch. A
connector will display between PSAX and the destination switch.
6. From the Edit menu select Disable Editing.
7. When asked to confirm, choose Yes to save the changes or No to disable editing
without saving any changes.
To Next Page
Loading...
Need help?
General
