Beta Draft Confidential
Configuring ATM Over MPLS Trunks
About ATMoMPLS Trunks
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/058-7
Module Support
This section describes the Lucent ATM edge switches and Juniper MPLS routers that
provide support for the ATMoMPLS trunking solution described in this chapter.
Lucent Switches
ATMoMPLS trunk support is provided for the module types described in Table 8-1.
Juniper Routers
The Juniper routers and physical interface cards (PICs) described in Table 8-2 support
interoperability with Lucent switches via ATMoMPLS trunking. The required
software release is JUNOS Release 6.4 or above.
Table 8-1. Supported Lucent Switches and Modules for ATMoMPLS
Trunking
Switch Supported Modules
CBX 3500
• 4-port OC-12c/STM-4 module with Universal IOP module
CBX 500
• 1-port OC-12c/STM-4 module with 128MB on CBX 500 IOM1
module
GX 550
• 1-port OC-12c/STM-4 Phy module with 128MB on GX 550
BIO2 module
Note – For more information about module names, descriptions, and types, see
the Switch Module Configuration Guide
for CBX 3500, CBX 500, GX 550, and
B-STDX 9000
.
Table 8-2. Supported Juniper Routers and PICs for ATMoMPLS
Trunking
Router Supported Physical Interface Cards (PICs)
T640
OC-12c 2-port ATM2 PIC
T320
OC-12c 2-port ATM2 PIC
To Next Page
Loading...
Need help?
General
