Beta Draft Confidential
Configuring ATM Over MPLS Gateway Solution on CBX 3500
Configuring PWE3 Over MPLS Core Network
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/059-63
6. When you complete the configuration, choose OK to save the changes and close
the dialog box.
Table 9-25. Add LDP Entity Dialog Box Fields
Field Description
Name Enter a unique alpha-numeric name for this LDP entity.
Admin Status Select either Enabled or Disabled to set the admin status of the
LDP entity.
Keep Alive Hold
Timer (1-65535)
An LSR maintains a Keep Alive timer (in seconds) for each
peer session which it resets whenever it receives an LDP PDU
from the session peer. If the Keep Alive timer expires without
receipt of an LDP PDU from the peer, the LSR concludes that
the transport connection is bad or that the peer has failed, and it
terminates the LDP session by closing the transport connection.
After an LDP session has been established, an LSR must
receive an LDP PDU from the peer at least once every
KeepAlive time period to ensure the peer restarts the session
Keep Alive timer.
Hello Hold Timer
(1-65535)
An LSR maintains a hold timer with each Hello adjacency. This
hold timer is restarted when a Hello matching the Adjacency is
received. If the timer expires without receipt of a matching
Hello from the peer, the LDP concludes that the peer no longer
wishes to label the switch using that label space for that link (or
target, in the case of Targeted Hellos) or that the peer has failed.
Enter the hello hold timer in seconds. The default is zero (0).
Target Peer
Address
From the pull-down list, select the IP address of the remote
LSR.
Edit Non-Lucent IP If the remote LSR is not Lucent equipment, check the User
Configured LSR ID box, then enter the IP address of the LSR.
To Next Page
Loading...
