Beta Draft Confidential
8-21/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring ATM Over MPLS Trunks
ATMoMPLS Trunk Licensing
ATMoMPLS Trunk Licensing
If you intend to use the ATMoMPLS trunking features on CBX 3500, CBX 500, and
GX 550 switches in your network, you will require a license key. If you do not enter a
license key, the NMS will not enable you to create and administer ATMoMPLS
logical ports or ATMoMPLS trunks.
After you enter a license number at the NMS, Navis EMS-CBGX enables you to
configure ATMoMPLS trunking features up to the maximum number supported by
your license. Navis EMS-CBGX issues a warning if you approach the maximum limit,
enabling you to upgrade your license in advance should you expect to exceed the
maximum number of switches in the future.
This section contains the following topics:
• “How to Order an ATMoMPLS Trunking License” on page 8-2
• “Managing License Keys With Navis EMS-CBGX” on page 8-3
• “How the ATMoMPLS License Works” on page 8-4
How to Order an ATMoMPLS Trunking License
Before calling a Lucent Technologies representative to discuss your licensing
requirements, please ensure that you have read this document and that you have the
required information at hand.
To order a license to use ATMoMPLS trunks, you will need the Host ID of the NMS
system, and the backup/standby NMS if applicable, for each management domain in
which you plan to use ATMoMPLS trunks. To find out the Host ID, enter
hostid in a
Terminal window and press Return.
To Next Page
Loading...
Need help?
General
