Beta Draft Confidential
4-36 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring ATM Logical Ports on Frame-based Modules
Defining ATM Direct Trunk and OPTimum Cell Trunk Logical Ports
Defining ATM Direct Trunk and OPTimum Cell Trunk
Logical Ports
This section describes how to configure an ATM direct trunk or ATM OPTimum cell
trunk logical port. These logical port types are only available for the 1-port ATM CS
DS3/E3, 1-port ATM IWU OC-3c/STM-1, and ATM UNI DS3/E3 cards.
ATM Direct Trunks
To configure an ATM direct trunk, perform the following steps:
Step 1. Configure the physical port you want to use for the direct trunk (see the Switch
Module Configuration Guide for CBX 3500, CBX 500, GX 550, and
B-STDX 9000). You can configure direct trunks on any of the following ATM
modules:
•
1-port ATM CS DS3/E3
• 1-port ATM IWU OC-3c/STM-1
• ATM DS3/E3 UNI
Step 2. Configure an ATM direct trunk logical port on the physical port.
Step 3. Configure the trunk (see Chapter 7, “Configuring Trunks”).
To Next Page
Loading...
Need help?
General
