Beta Draft Confidential
3-501/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring CBX or GX Logical Ports
Setting Logical Port Attributes
Tunnel VP Shaping Rate Attributes
The Tunnel VP Shaping Rate tab is available for CBX 500 and GX 550 OPTimum cell
trunk logical ports. If this LPort is on a CBX 500 switch, FCP and VP Shaping must
also be enabled on the card.
The number of VPI Shaping Rate fields on the Tunnel VP Shaping Rate tab is
determined by the settings in the VPI Range tab. In Figure 3-19, a range of 1-15 was
specified in the VPI Range tab.
Figure 3-19. Add Logical Port: Tunnel VP Shaping Rate Tab
For each Tunnel VPI Shaping Rate field in this tab, enter the shaping rate for the VPI
value. A VPI.n Shaping Rate field is displayed for each VPI value in the range entered
in the VPI Range tab. The default value is 100.
To Next Page
Loading...
