Beta Draft Confidential
Configuring ATM Over MPLS Gateway Solution on CBX 3500
Configuring a Layer 2 Tunnel Over MPLS Core Network
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/059-39
3. Complete the fields in the Add IP Interface address dialog box, as described in
Table 9-15.
4. When you complete the configuration, choose OK to save the changes and close
the dialog box.
Configuring OSPF IP Parameters
To configure OSPF IP interface parameters on a logical port:
1. Expand the instance node for the IP LPort that you want to configure.
2. Expand the IP Interface Address class node.
3. Expand the instance node of the IP Interface Address on which you want to
configure OSPF interface parameters.
4. Right-click on the OSPF Interface class node and select Add from the pop-up
menu.
The Add OSPF IP Interface dialog box appears (Figure 9-20).
Table 9-15. Add IP Interface Address Dialog Box Fields
Field Action/Description
Unicast Address
IP Address Specify the IP address for this interface. Interface addresses can
be distributed across IP logical ports as required.
Network Mask Specify the mask used to determine the subnet of this IP interface.
Once this value is set, you cannot use the Modify Interface
Address function to modify the network mask value. In order to
change the network mask, you must delete the IP interface and
then add a new one using the correct network mask.
Max Transfer
Unit (MTU)
Specify the maximum size of a packet that can be sent through the
physical port. The default value for a PPP LPort is 1500.
Miscellaneous Params
Admin Status Enable – (default) Enables IP interface address status.
Disable – Disables IP interface address status.
To Next Page
Loading...
Need help?
General
