Beta Draft Confidential
18-81/19/05 ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000
Configuring SPVCs
Defining a Point-to-Point Offnet Circuit Connection
5. Continue with “Selecting the Terminating Endpoint Address” below.
Selecting an Endpoint From a Physical Port
To select an endpoint from a physical port:
1. In the Select Endpoints dialog box, expand the node for the desired switch for
Endpoint 1.
If you are creating an Offnet Circuit from an LPort node, Endpoint 1 is already set
for that LPort. Skip to step 8.
2. Expand the Cards node under the switch and expand the node for the desired card
or module.
3. Expand the PPorts node and expand the node for the desired physical port.
4. Expand the LPorts node and select the desired LPort.
5. Select the SVC Address or the Select Address tab to select or create a Terminating
Endpoint.
6. Continue with “Selecting the Terminating Endpoint Address.”
Selecting the Terminating Endpoint Address
To complete this configuration:
1. If you know the SVC terminating endpoint address, select it from the SVC
Address tab (Figure 18-2 on page 18-7).
2. If you do not know the address, choose the Select Address tab (Figure 18-2 on
page 18-7), and use Table 18-3 to select the address format and configure the
terminating endpoint address. For more information on ATM End System Address
(AESA) formats, see page 16-2.
To Next Page
Loading...
Need help?
General
