Beta Draft Confidential
Configuring ATM PVCs
Configuring PMP Circuits
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/0510-83
Selecting a PMP PVC Leaf Endpoint
To select a PMP leaf endpoint:
1. In the Add Point-to-Multipoint PVC Leaf dialog box, choose the Select button in
the Endpoint field.
The Select Endpoint dialog box appears (see Figure 10-19 on page 10-73).
2. Select the PMP leaf endpoint by using either of the following procedures:
• “Selecting an Endpoint From a Switch” on page 10-74.
• “Selecting an Endpoint From a Physical Port” on page 10-75.
3. Continue with “Configuring PMP PVC Leaf Parameters.”
Configuring PMP PVC Leaf Parameters
To configure PMP PVC leaf parameters, you enter information in each of the
following tabs, categorized by parameter type:
• Administrative
• Accounting
Before You Begin
Before you configure the parameters for a PMP leaf, you must select the PMP leaf
endpoint. If you are creating a PMP PVC leaf from an LPort instance node, you do not
need to select an endpoint. Continue with step 1 below.
To configure PMP PVC leaf parameters:
1. In the Add Point-to-Multipoint PVC Leaf dialog box, select the Administrative
tab (Figure 10-26 on page 10-84).
To Next Page
Loading...
Need help?
General
