Beta Draft Confidential
Configuring ATM PVCs
Completing the Redirect PVC Configuration
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/0510-39
Completing the Redirect PVC Configuration
To complete the redirect circuit configuration:
1. (Optional) To configure NavisXtend Accounting Server parameters for this
circuit, select the Accounting tab. For more information, see the NavisXtend
Accounting Server Administrator’s Guide.
2. (Optional) To configure CBX 500 or GX 550 NDC parameters for this circuit,
select the NDC tab. For more information, see the Switch Diagnostics User’s
Guide
for CBX 3500, CBX 500, GX 550, and B-STDX 9000.
3. To add more redirect PVCs, repeat the steps in “Defining Redirect PVCs” on
page 10-35.
4. Choose OK to close the Add Redirect PVC dialog box and save the configuration.
Setting the Redirect PVC Delay Time
You configure the Redirect PVC Delay Time on the Add Logical Port dialog box
(Figure 3-5 on page 3-8 or Figure 4-3 on page 4-21) for ATM UNI and NNI logical
port types. This option enables you to set the number of seconds to wait before the
network initiates call clearing after a circuit goes down.
You configure the Redirect PVC Delay Time only for the primary endpoint.You can
reset this field at any time; the range is zero (0) – 255 seconds. Entering zero (0)
(default) in this field causes the network to immediately initiate call clearing, which
can trigger the switchover between a working redirect PVC endpoint and its primary
or secondary endpoint. Increasing the value can minimize the Redirecting PVCs as a
result of temporary DTE state changes.
To Next Page
Loading...
Need help?
General
