Ruijie RG-WLAN Series - Page 26

Command Reference Dot11 Radio Commands
Parameter
Description
Parameter Description
no
Restores the default value.
Defaults
The default value is 54.
Command
mode
Dot11radio interface configuration mode
Usage Guide
A multicast rate takes effect only when the current AP frequency band supports this rate. If this rate is
not supported, the default rate is used.
Configuration
Examples
# Set a multicast rate.
Ruijie(config)#interface dot11radio 1/0
Ruijie(config-if-Dot11radio 1/0)# mcast_rate 24
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
sta-limit
Use this command to set the maximum number of wireless clients that can be connected to the AP.
sta-limit client-num
no sta-limit
Parameter
Description
Parameter Description
no
Restores the default value.
client-num
Specifies the maximum number of clients. The range is from 1 to 128.
Defaults
The default value is 24.
Command
mode
Dot11radio interface configuration mode
Usage Guide
N/A
Configuration
Examples
# Set the maximum number of wireless clients to 50.
Ruijie(config)#interface dot11radio 1/0
Ruijie(config-if-Dot11radio 1/0)# sta-limit 50