Ruijie RG-WLAN Series Rgos Command Reference

Command Reference WLAN-VLAN Mapping Commands
Defaults
The default VLAN is not specified.
Configuration
Mode
VLAN group configuration mode
Usage Guide
Before setting the mode of assigning the default VLAN, add the default VLAN to the specific
VLAN group.
The default VLAN takes effect only after it is assigned to a user who passes 802.1x
authentication by the authentication server of the current WLAN.
Configuration
Examples
The following example shows how to set VLAN 10 to the default VLAN of VLAN group 100 on
an AP:
Ruijie# configure terminal
Ruijie(config)# vlan-group 100
Ruijie(config-vlan-group)# default-vlan 10
Command Description
Related
Commands
show vlan-group [group-id]
Display information about a VLAN group.
Platform
Description
This command is supported by the RGOS10.4 (1T17) or later versions.
vlan-list
Use this command to set the list of VLANs in a VLAN group on an AP device. Use the no form of this
command to remove the setting.
vlan-list vlan-list
no vlan-list
Parameter Description
Parameter
Description
vlan-lis
Specifies a list of VLANs in a VLAN group. A VLAN group
includes a maximum of 32 VLANs.
Defaults
A VLAN group has no VLAN.
Configuration
Mode
VLAN group configuration mode
Usage Guide
If a WLAN needs to map multiple VLANs, add them to the same VLAN group, and then
associate the VLAN group with the WLAN.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English