Ruijie RG-WLAN Series - Page 38

Command Reference WLAN-VLAN Mapping Commands
Configuration
Examples
The following example shows how to add VLANs 100 to 105 to VLAN group 100 on an AP or
AC:
Ruijie# configure terminal
Ruijie(config)# vlan-group 100
Ruijie(config-vlan-group)# vlan-list 100-105
Command Description
Related
Commands
show vlan-group [group-id]
Display information about a VLAN group.
Platform
Description
This command is supported by the RGOS10.4 (1T17) or later versions.
vlan-group
Use this command to associate a VLAN group with the current WLAN on an AP. Use the no form of
this command to remove the configuration.
vlan-group group-id
no vlan-group
Parameter Description
Parameter
Description
group-id
Specifies the ID of a VLAN group, which ranges from 1 to
128.
Defaults
The WLAN is not associated with any VLAN group.
Configuration
Mode
WLAN configuration mode
Usage Guide
None
Configuration
Examples
The following example shows how to associate WLAN 1 with VLAN group 100:
Ruijie# configure terminal
Ruijie(config)# dot11 wlan 1
Ruijie(dot11-wlan-config)# vlan-group 100
Command Description
Related
Commands
Platform
Description
This command is supported by the RGOS10.4 (1T17) or later versions.