Reference Guide 6. Show Commands
Version 7.2 103 Mediant MSBR
6.3.8 show data crypto
This command displays information about the encryption module.
Syntax
show data crypto
Command Description
Displays the configuration of the IPSec VPN.
Displays diagnostic information about the IPSec VPN.
Displays information about the active VPN server.
Displays the status of the IPSec VPN.
Command Mode
Basic User and Privileged User
Note
This command is applicable only to data-router functionality.
Example
This example displays diagnostic information about the IPSec VPN:
show data crypto debug
Kernel routing table:
169.254.254.252/30 dev eth0.4001 scope link src 169.254.254.253
metric 4
169.254.254.252/30 dev ipsec1 scope link src 169.254.254.253
metric 5
172.17.141.0/24 dev eth0.1 scope link src 172.17.141.163 metric
4
172.17.141.0/24 dev ipsec0 scope link src 172.17.141.163 metric
5
10.25.116.0/24 dev eth0.5 proto static scope link metric 1
default via 172.17.141.1 dev eth0.1 proto static metric 1
---
Data Interfaces:
---
eth0 Link encap:Ethernet HWaddr 00:90:8F:8C:D3:27
inet6 addr: fe80::290:8fff:fe8c:d327/64 Scope:Link
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500
Metric:1
RX packets:2792505 errors:0 dropped:0 overruns:0 frame:0
TX packets:5753622 errors:0 dropped:0 overruns:0
carrier:0
collisions:0 txqueuelen:100